Here is a Guide to installing 10.11.4 on a HP Probook 4530s using Clover Hotpatch. This guide will also work on different models will require different SSDT.

The main reason I bought the Probook 4540s was because of it’s hardware spec which is very similar to a Macbook and therefore well supported by OS-X. I use a Mac for my photo processing with Lightroom so I wanted to try to get OS-X running for when we go on holiday etc. The first part of installing OS-X was to create a bootup usb stick using the software from the tonymacx86 site. This uses a legal copy of OS-X Mountain Lion which I had bought for my iMac to create a boot/install system which will run on an intel based machine. Canon F151 300 Driver. My first attempt at booting the laptop from this machine resulted in a black screen, but I found that if I passed in the parameters “useKernelCache=no GraphicsEnabler=no -r -f” I could get to the installer screen. From this point I used the mac disk utility to format the partition I was installing OS-X to as HPFS+ and then started the install going. The install process itself is easy enough to negotiate – any options which need to be selected are obvious and involve just one reboot prior to setting user accounts etc. Phpstorm Mac Keygen Generator.

Once the install was complete I had OS-X installed on my probook! The only issues I had were • The wifi/bluetooth adapter is not supported by OS-X and was not recognized • I could only boot OS-X with the usb stick plugged in WiFi The wifi situation was also affecting Linux because the internal adaptor was not being recognized in linux either.

I could more easily solve that problem in linux because of the wider hardware support in that OS, so I tried to find a usb wifi dongle that would work in Mountain Lion. This proved to be more problematic that I thought because althought I found a couple of devices which were listed as being supported in OS-X, it turned out they were supported in 10.5 or 10.7 but not 10.8. I eventually solved this by downloading the driver for one of the devices I tried, and Edimax EW-7811Un, from the realtek site directly. This got me going with wifi, and then I discovered a direct replacement for the internal half-size pci-e wifi card from a supplier in Hong Kong. This was an Atheros AR9280 card which cost me 3. Emachines E627 Touchpad Scroll Not Working. 60 pounds + 2.99 pounds postage. Once this turned up and was fitted the native OS-X airport utility found my network and connected immediatly. Booting Booting the machine turned out to be a real problem.

I wanted to run the machine in efi mode which should have been easier to multiboot but there is limited support for efi booting of OS-X. It took me about two weeks to finally get the system sorted, but in the end I did by using two bootup menu systems. The first menu system I used is called. I set this up with manual stanzas to load Linux and Windows 7. I couldn’t use refind to load OS-X because OS-X needs additional kernal drivers (or kexts) to be loaded so I used a different menu system for OS-X called which allows these drivers to be loaded. I set refind to have an entry which points to clover, and set clover to boot OS-X by default with no delay. This gives me a single menu system with just three entries.